Specifies when the period of counting data usage should begin. After the period is over, the limit is reset and the count begins over again. External antennas used with RUT240 must be installed to provide a distance of at least 20 cm from any people and must not be co-located or operated in conjunction with any other antenna or transmitter. Fixed mac80211 vulnerabilities CVE-2022-41674, CVE-2022-42719, CVE-2022-42720, CVE-2022-42721, CVE-2022-42722 An external SIM holder and signal strength status LEDs make network management easy with the Teltonika RUT240 Router. Maximum time (in seconds) the button can be held to perform an action, after which no action will be performed.

Changes the interface's allowed maximum transmission unit (MTU) size. It is the largest size of a protocol data unit (PDU) that can be transmitted in a single network layer transaction. Sends LCP echo requests at the given interval in seconds. This function is only effective in conjunction with failure threshold. RUT240 router must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments.

The UDP Broadcast Relay will listen for broadcast traffic on the specified port and relay that traffic to the specified interface(s). Presumes peer to be dead after given amount of LCP echo failures. Leave it at 0 to ignore failures.

In General Setup tab change Mode to Multi AP, select desired Network which will be attached to the interface. You can also select scan time and upload file with Access Points list. The Firewall Settings section is used to specify to which firewall zone if any this interface belongs. Assigning an interface to a zone may provide easier configuration of firewall rules. For example, instead of configuring separate rules for each WAN interface, you can add all WAN interfaces into a single firewall zone and make the rule apply to that zone instead.Fixed preserving the contents of /etc/luci-uploads/ after FW upgrade with the 'Keep all settings' option The DHCP protocol is used to set up an interface which obtains its configuration parameters automatically via a DHCP lease.