Scope: it means the farthest distance that the motion axle can move, which is determined in accordance with the actual condition of the machine. And, the pulse signal can be falling edge valid or rising edge valid. The default setting is falling edge valid. Connect your laser to the computer: Next, you will need to connect your Monport laser to your computer using a USB cable. Make sure that the laser is turned on and that the USB port on your computer is working properly.

The Ruida RDC6445G/S CNC system is a laser controller that is used to control CO2 laser cutting or engraving machines. It provides a user-friendly interface for operating the laser and offers various functions such as cutting path planning, laser power control, and real-time laser parameter adjustments. The RDC6445G/S system supports multiple communication protocols and is compatible with a range of laser cutting and engraving machines. A DSP laser will have homing switches - one on each axis. They might be physical lever-type micro switches, optical beam-break switches, or inductive proximity sensors. Locate the switch at the end of the X axis, and the one for the Y axis. Note that the Ruida homes using the X- and Y- limit switches. Water protection enables: When the water protection enabled, the controller must connect the wiring, otherwise the machine will not emit laser. If disable, no need to connect the water protect wiring, controller will not test. One of them is the 24 volt power supply. If you follow the wires through, that’s the power that goes and runs the controller.Machine interface: The controller should have a clear and easy-to-use interface that allows for precise control over the laser-cutting process. Ruida RDC6332M hybrid cutting controller is a hybrid cutting system based on the proven RDC6332G co2 laser controller, which is specially developed to combine the processing of sheet metal and non-metal cutting. Based on this co2 laser DSP controller, it can realize metal cutting and non-metal cutting. I’ve attached a video of what I’m talking about and pictures of the controller with the lights on but only before the real startup sequence happens otherwise it starts banging. This control system employs single 24 power supply. For a certain margin, it is suggested to select 24V/2A above power. Besides, this system is compatible with 36V power, that is to say, the 36V power of Motion driver can directly be connected to this main power port of this system, but generally it is not Set Origin 1/2/3/4: after the multiple- origin logic is enabled, you can stop the cursor at “Set as Origin 1/2/3/4”. Press the “Enter” key on the keyboard and the system will take the coordinate figures of current X/Y axis as the corresponding ones to the origin 1/2/3/4.

Now, the next axis is called U, and basically it’s an uncommitted control system which allows you to drive a stepper motor, If we take a look at the top left hand corner there, we should see that the main’s comes into a filter. Import artwork in a variety of common vector graphic and image formats(including Al.PDF, SVG, DXF, PLT, PNG, JPG, GIF, and BMP)This part is just doing rough adjustment - it's not accurate at all, but you need to get into the right ballpark before doing the next part.

Key Acceleration: it means the acceleration to move this axis by way of the keys on the keyboard, which can’t be higher than the maximum acceleration of this axis. Vector graphics editing: RDWorks allows you to import vector graphics in a variety of formats, including DXF, AI, and PLT, and edit them by adding or deleting lines, curves, and shapes. Raster image processing: RDWorks also supports the import and editing of raster images, such as JPG and BMP, for use in laser engraving applications. Push the “Y+/-“ Keys to move the cursor to one of the entry, then push “Enter” key to restart the selected axis, the screen will show some information when resetting. Manual set+Enable the blower: if use Wind signal of output port to control the blower switch as layers, you must enable this item, otherwise, the Wind signal outputs other signal. Figure 7.2-1 Output Example Chapter8 Human-Computer Interface Operating Instruction Panel and Keys The Operation Panel